Initializing The Scanner To Factory Defaults - Radio Shack 20-106 User Manual

Additional Information
4. Press ENT. The scanner displays:
GLOB EEPROM area
Initialized to
defaults.
Press any key.
5. Press any key on the keypad to proceed.
The scanner will reboot with file system and
global parameters reset to factory defaults.

Initializing the Scanner to Factory Defaults

If initializing the global parameters to factory
defaults does not resolve your problem, you
may wish to initialize the entire scanner to
factory defaults. This operation will result in the
clearing of your programmed data and the loss
of any custom changes you have made to the
radio's global parameters. Use this option as a
last resort, and, if possible, save your working
memory to a V-Scanner folder prior to performing
this operation.
Note: This procedure clears all information you
stored in the scanner's working memory, AND
resets the global parameters to factory defaults.
Initialize the scanner only when you are sure
the scanner is not working properly. V-Scanner
memory is not affected when the scanner is
initialized.
1. Turn off the scanner, then turn it on again.
The scanner briefly displays the DSP boot
version, and then the Welcome/Owner screen
is displayed.
98
Additional Information
2. Press 0 while the scanner is displaying the
Welcome/Owner screen. The scanner displays:
System Tests:
Select a Test...
Exits if no key
is pressed
3. Press 1. The scanner displays:
Factory Init
Erase Memory
ENTER if APPROVE
CLEAR to EXIT
4. Press ENT. The scanner displays:
Initializing the
File System
Please Wait.....
5. Press any key on the keypad to proceed. The
scanner displays:
GLOB EEPROM area
Initialized to
defaults.
Press any key.
6. Press any key on the keypad to proceed.
The scanner will reboot with file system and
global parameters reset to factory defaults.
File System
Initialized to
Defaults.
Press any key.
99