Programming With A Personal Computer; Initializing The Scanner; Preprogrammed Frequencies - Radio Shack 20-405 User Manual

Programming with a Personal Computer

You can upload or download programmed data to or from a PC using a USB
cable available from your local RadioShack store or www.RadioShack.com.
The application software is available online. Use a search engine to find
"scanner programming software." Follow instructions in the software package
to upload and download data.

Initializing the Scanner

If the scanner's display locks up or does not work properly after you connect a
power source, you might need to initialize the scanner.
n
Important: This procedure clears all information you stored in the scanner's
memory. Only initialize the scanner when you are sure the scanner is not
working properly.
1. Turn off the scanner, then turn it on again. WELCOME SCAnnInG rECEIVEr
appears.
2. Press 0, then press 1 while the welcome message is on the screen. InItIAL
appears for about two seconds, then YES — Ent and No — CLEAr appear
alternately.
. Press ENT. WAIt appears for about two seconds.
n
Note: Do not turn off the scanner until the initialization is complete. When
the initialization is complete, 1CH 000.000

Preprogrammed Frequencies

Your scanner has 153 preprogrammed frequencies in the ROM. You can load
them into Channels 1 to 153.
1. Turn off the scanner and then turn it on again.
2. While WELCOME message appears, press PGM.
. Load –Fr– appears, then YES––Ent and No––CLEAr appear alternately.
4. Press ENT to load frequencies or press CLEAR to cancel.
appears on the display.
0
2