Porter-Cable 7529 Instruction Manual page 9

900468 - 07-11-02.qxd 7/25/02
6. Engage spindle lock (Q) Fig. 10
by pressing on it while turning
chuck (E) Fig. 10 until it locks into
place.
7. Tighten collet nut (D) Fig. 10
with wrench provided.
8. To remove bit, loosen collet
nut. If bit does not remove easily,
continue to loosen the collet nut
until the nut forces the collet
retaining ring to lift and free collet.
9. Reinstall the chip deflector.
ADJUSTING PLUNGE DEPTH
1. DISCONNECT TOOL FROM POWER SOURCE.
2. Loosen depth rod locking knob (K) Fig. 11, and depth indicator knob, (J)
Fig. 11, allowing the depth rod (L) Fig. 11 to contact one of the depth stops
(M) Fig. 11.
Normally the deepest cut is set
with the depth rod (L) Fig. 12,
resting on the base casting (A) Fig.
12. Adjust the three adjustable
stops (B) Fig. 12 to any desired
height to allow stock removal in
steps. This action will prevent
overloading motor and/or the
various depths that may be
required for a particular job.
3. Release plunge mechanism
by pulling the locking lever (C) Fig.
8 to the left and lower plunge
mechanism until the router bit just
touches the work surface. Release
lever and push to the right to lock
mechanism in this position.
4. Tighten depth rod locking
knob (K) Fig. 11.
5. Position depth indicator (J)
Fig. 9 at "O" position and tighten
knob.
9:24 AM Page 9
D
E
Fig. 10
J
H
L
Fig. 11
A
Fig. 12
9
Q
K
M
L
B