Checklist Before Starting Engine - Generac Portable Products 2400PSI Owner's Manual

Figure 5 — Connect High Pressure Hose to Gun.
• Attach the other end of the high pressure hose to the
high pressure fitting on the pump (Figure 6). Tighten by
hand.
Figure 6 — Connect High Pressure Hose to Water Outlet.
• Before you connect your garden hose to the water inlet,
inspect the inlet screen (Figure 7). Clean the screen if it
contains debris, replace it if it is damaged. DO NOT
RUN THE PRESSURE WASHER IF THE SCREEN IS
DAMAGED.
Figure 7 — Connect Garden Hose to Water Inlet.
Connect
Garden Hose
Here
Generac Portable Products 2,400 PSI High Pressure Washer
Connect High Pressure
Hose Here
Connect High
Pressure Hose
Here
• Run water through your garden hose for 30 seconds to
clean out any debris. Turn off water.
• Connect the garden hose to the water inlet. Tighten by
hand (Figure 7).
WARNING!
unrestricted garden hose between the pressure
washer inlet and any flow shut off device, such as a
'Y' shut-off connector or other convenience-type
water shut-off valve. Damage to pressure washer
resulting from disregarding this warning will not be
covered by the warranty.
• Turn ON the water.
• Squeeze the trigger on the gun until you have a steady
stream of water. This purges the pump of air and
impurities.
CAUTION!
be sure you are wearing adequate eye protection.
CHECKLIST BEFORE
STARTING ENGINE
Review the unit's assembly to confirm you have performed
all of the following:
• Make sure the handle and wireform are in place and
secure.
• Check that oil has been added to the proper level in the
engine crankcase.
• Add the proper gasoline to fuel tank.
• Check for properly tightened hose connections.
• Check to make sure that there are no kinks, cuts, or
damage to the high pressure hose.
• Provide a proper water supply (not to exceed 140°F) at
an adequate flow.
• Be sure to read "Safety Rules" and "How To Start the
Engine" before operating your pressure washer.
7
There MUST be at least ten feet of
Before starting the pressure washer,