Checklist Before Starting Engine - Generac Portable Products 1540-0 Owner's Manual

CAUTION!
There MUST be at least ten feet of
unrestricted garden hose between the pressure washer
inlet and any flow shut off device, such as a 'Y' shut-off
connector or other convenience-type water shut-off valve.
Damage to pressure washer resulting from disregarding this
warning will not be covered by the warranty.
• Attach the nozzle extension to the spray gun. Tighten by
hand (Figure 5).
Figure 5 — Connect Nozzle Extension to Spray Gun
• Turn ON the water and squeeze the trigger on the spray
gun to purge the pump system of air and impurities.
CAUTION!
Before starting the pressure washer,
be sure you are wearing adequate eye protection.
Generac Portable Products 3,500 PSI High Pressure Washer

Checklist Before Starting Engine

Review the unit's assembly to confirm you have performed
all of the following:
• Make sure the handle is in place and secure.
• Check that oil has been added to the proper level in the
engine crankcase.
• Add the proper gasoline to fuel tank.
• Check for properly attached hose connections.
• Check to make sure that there are no kinks, cuts, or
damage to the high pressure hose.
• Provide a proper water supply (not to exceed 100°F) at
an adequate flow.
• Be sure to read "Safety Rules" and "How To Use Your
Pressure Washer" before using the pressure washer.
7