Table of Contents
Advertisement
A
X
4
S
-
U
/
A
X
A
X
4
S
-
U
/
A
X
Host Adapter BIOS
This option enables or disables the SCSI controller BIOS. The default setting is Enabled.
The SCSI controller BIOS must be enabled if you want the system to boot from a SCSI hard disk drive connected to the SCSI
controller. Several SCSISelect™ options cannot be used unless the SCSI controller BIOS is enabled.
Display <Ctrl-A> Message During BIOS Initialization
This option allows entering the SCSISelect™ utility during BIOS initialization. The default setting is Enabled.
Extended BIOS Translation for DOS Drives > 1 GByte
This option allows you to enable or disable extended translation for SCSI hard disks with a capacity greater than 1 GB. This is
valid only if the SCSI controller BIOS is enabled. The default factory setting is Enabled.
When enabled, this option uses the following translation schemes:
SCSI hard disks < 1 GB use a translation scheme of 64 heads, 32 sectors per track
SCSI hard disks > 1 GB use a translation scheme of 255 heads, 63 sectors per track
See the section Disk Drives Over 1 GB" in this chapter, for
more information on this option. This option should be left
disabled for most operating systems except DOS.
4
S
P
l
u
s
-
U
4
S
P
l
u
s
-
U
O
n
l
i
n
e
O
n
l
i
n
e
113
M
a
n
u
a
l
M
a
n
u
a
l
Advertisement
Table of Contents
