Page 1
FOR ADJUSTMENT, WEAR, AND DAMAGE. THEREFORE, YOU MUST READ AND UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS SUPPLIED WITH YOUR YAKIMA PRODUCT PRIOR TO INSTALLATION OR USE. IF NO PRE-ASSEMBLY REQUIRED YOU DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND...
Page 2
CROSSBAR SPREAD Q TOWERS: NEVER REPOSITION THE TOWERS! RocketBox 16 ....30" - 36" (76 - 91 cm) RocketBox 11..... 30" - 36" (76 - 91 cm) BARS THAT MOVE: TIGHTEN YOUR CROSSBARS IF RocketBox 15s ....24" - 36" (61 - 91 cm) YOU LOOSENED THEM.
Page 3
OPEN LID TO GAIN ACCESS TO KNOBS. Slide clamps along tracks (inside box) to engage crossbars. • Check clamp opening for crossbar clearance. • Loosen red knob further if necessary. Adjust box on top of car. Measure from towers for reference. Tighten knobs to TIGHTEN ALL engage clamps.
Page 4
Remove key. * See 11a below. REPLACEMENT LOCK FOR SAME-KEY-SYSTEM® USERS: Yakima SKS® locks purchased separately. (If you wish to install matched-key locks; keep this instruction for replacement lock installation). • Insert lock key and rotate the lock to Remove key Insert control key into the •...
Page 5
BE SURE ALL HARDWARE IS Periodically ATTACHMENT ONLINE TO SECURED ACCORDING TO check the knobs HARDWARE CAN INSTRUCTIONS. FAILURE TO WWW.YAKIMA.COM OR EMAIL US AT LOOSEN OVER TIME. inside the box PERFORM SAFETY CHECKS CHECK AND TIGHTEN YAKWARRANTY@YAKIMA.COM and tighten if BEFORE DRIVING AWAY...
Need help?
Do you have a question about the GEAR BOXES and is the answer not in the manual?
Questions and answers