Siemens ZTH Getting Started page 26

Installing
3.2 Installing Control Unit
Procedure
To select one of the inverter's pre-assigned settings, proceed as follows:
1. Think about which of the input and output functions you are using in the application.
2. Find the I/O configuration (macro) that best suits your application.
3. Note the macro number of the corresponding default setting.
You must set this macro number when putting the frequency inverter into operation.
You have found the appropriate inverter pre-assignment.
Macro 1: Two fixed speeds
DI 4 and DI 5 = high: The inverter adds
both fixed speeds.
Macro 4: PROFIBUS or PROFINET
PROFIdrive telegram 352
26
Macro 2: Two fixed speeds with safety
function
Macro 5: PROFIBUS or PROFINET
with safety function
PROFIdrive telegram 1
Macro 3: Four fixed speeds
Multiple DIs = high: The inverter adds
the corresponding fixed speeds.
Converters with CU250S-2 Control Units
Getting Started, 10/2013, FW V4.6, A5E32899990B AA