Husqvarna 345 Workshop Manual page 37

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Repair instructions
Air intake system – refitting
1
Fit the inlet manifold (A) through the insulating
plate in the carburettor flange cut-out (B), and
check that the insulating plate's impulse tube sits
correctly in the inlet manifold. Fit the perforated
brass support ring in the inlet manifold.
2
Fit the air intake system on the cylinder and snap
the insulating plate into position. Check carefully
that the impulse tube is correctly seated against
the cylinder's impulse channel.
3
Position tool 502 54 17-01 between the carburettor
flange and the insulating plate.
36
– English
A B
www.mymowerparts.com
4
Refit the carburettor. Screw in the carburettor bolts
directly from behind without lifting the carburettor
assembly, tightening to a torque of 1–1.5 Nm. It is
important to hold the carburettor flange securely
when tightening the bolts to prevent the inlet
manifold from moving.
4
Push down the rear carburettor mounting into the
rubber bushings using a small screwdriver. Re-
move tool 502 54 17-01.
5
Refit:
• cylinder, see special instructions
• silencer support (does not apply to 340, 345,
350)
• air filter
• HT lead
• cylinder cover
• after the test run retighten the silencer bolts to a
torque of 8–10 Nm