Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Service Manual
Crathco Powdered Beverage Dispensers
Operation and Instruction Manual
PSD (1, 2, & 3) DC & PIC-33A Series
TABLE OF CONTENTS
Warning Labels......................................2
Installation.........................................3
Start up Procedures................................3-4
How To Dispense Cappuccino.............4
Adjustments.......................................5-7
Service and Cleaning.........................7-11
Troubleshooting.................................12-13
Exploded Views...............................14-21
Wiring Diagram....................................22-26
Prior authorization must be obtained
from Grindmaster Crathco Systems for
all warranty claims.
Grindmaster Crathco Systems, Inc., 1996
Printed in the USA
for
PIC (1, 2, & 3) DC,
PIC-33A
PIC-2-DC
Grindmaster Crathco Systems, Inc.
4003 Collins Lane
Louisville, Kentucky 40245
(502) 425-4776 800-695-4500
(800) 568-5715
(technical service only)
FAX (502) 425-4664
www.grindmaster.com
PIC-1-DC
0900 Form # CC-302-12
Part # 61146
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Crathco PIC-33A Series
Summary of Contents for Crathco PIC-33A Series
-
Page 1: Table Of Contents
Crathco Powdered Beverage Dispensers Operation and Instruction Manual PIC (1, 2, & 3) DC, PSD (1, 2, & 3) DC & PIC-33A Series TABLE OF CONTENTS Warning Labels........2 Installation.........3 Start up Procedures........3-4 How To Dispense Cappuccino.....4 Adjustments........5-7 Service and Cleaning......7-11 PIC-33A Troubleshooting.........12-13... -
Page 2: Warning Labels
TION ON THE BACK OF INSTRUCCIONES DE AJUSTE CONSIGNES DE REGLAGE AU VERSO THE ACCESS PANEL. DENTRO DEL PANEL DE ACCE- DE LA PLAQUE D’ACCES. Part #61325, Located on the drain hose inside the dispenser Crathco Powdered Beverage Dispensers Page 2... -
Page 3: Installation
Note: If water supply is allowed to run dry, watchdog timer circuit may disable fill circuit. Ensure adequate water supply for machine then reset machine by turning power switch off 1 second then ON. Crathco Powdered Beverage Dispensers Page 3... -
Page 4: Start Up Procedures
Note: Portion may be cancelled by push and release of the switch. Note: Cup must rest flat on tray with 1/4” (6 mm) clearance between cup and spout. Contents can cause severe burns if handled improperly. Crathco Powdered Beverage Dispensers Page 4... -
Page 5: Adjustments
6. If the portion size is incorrect, repeat steps 1, 2, 3, 4 & 5 until the desired portion size is achieved. (On models starting with PIC-33A with 3 portion sizes per head.) 1. Place a cup under the selected drink dispense nozzle. - Page 6 Note: Clockwise rotation will result in a stronger drink and counterclockwise will result in a weaker drink. Note: Water flow rate is factory preset at approximately 0.80 ounces per second. Figure A Crathco Powdered Beverage Dispensers Page 6...
-
Page 7: Service And Cleaning
"ON" position. Dispense one to two cups until the water is clean. Short bursts of dispensing may also help clean the chambers. When completed, return the rinse switch to the "OFF" position. Figure D 3. Remove the hoppers and refill with product. Crathco Powdered Beverage Dispensers Page 7... - Page 8 8. Remove the palnut at the rear of the hopper by turning it counterclockwise, then remove the driveshaft bearing from the inside of the hopper. 9. All parts in contact with food must be washed, rinsed, sanitized, and air dried. Figure H Crathco Powdered Beverage Dispensers Page 8...
- Page 9 7. Once the tank is empty, securely replace the plug and clamp on the end of the hose. Reposition the drain hose inside the hose clip on the left side wall. 8. Reassemble the front access panel and drain tray. Crathco Powdered Beverage Dispensers Page 9...
- Page 10 Rinse, sanitize and air dry the tube. 6. Reassemble the parts in reverse order. Figure K Figure I Figure J Crathco Powdered Beverage Dispensers Page 10...
- Page 11 Gently insert both ends of the bulb into the socket and turn the bulb 1/4 turn to the right until the bulb locks into place. Replace the lightbulb panel. Reinstall the screws. Figure N Figure M Crathco Powdered Beverage Dispensers Page 11...
-
Page 12: Troubleshooting
Please have the model and serial numbers ready so that accurate information may be given. Prior authorization must be obtained from Grindmaster Crathco Systems, Inc. Technical Services Department for all warran- Crathco Powdered Beverage Dispensers... - Page 13 Wet wiring connections on harness Allow connections to dry ly dispenses from or controller dispense heads Drink is cold and Check for flashing lights on controller Refer to controller Diagnostics section ready light is on page 12 Crathco Powdered Beverage Dispensers Page 13...
-
Page 14: Exploded Views
Exploded Views PIC-2-DC, PIC-3-DC, PSD-2, and PSD-3 Crathco Powdered Beverage Dispensers Page 14... - Page 15 Exploded Views PIC-1-DC and PSD-1 Crathco Powdered Beverage Dispensers Page 15...
- Page 16 Water Tank Assembly PIC-2-DC, PIC-3-DC, PSD-2, and PSD-3 Crathco Powdered Beverage Dispensers Page 16...
- Page 17 Water Tank Assembly PIC-1-DC and PSD-1 Crathco Powdered Beverage Dispensers Page 17...
- Page 18 Hopper Assembly PIC-2-DC, PIC-3-DC, PSD-2, and PSD-3 Crathco Powdered Beverage Dispensers Page 18...
- Page 19 Hopper Assembly PIC-1-DC and PSD-1 Crathco Powdered Beverage Dispensers Page 19...
- Page 20 Door Assembly PIC-2-DC, PIC-3-DC, PSD-2 and PSD-3 Crathco Powdered Beverage Dispensers Page 20...
- Page 21 Door Assembly PIC-1-DC and PSD-1 Crathco Powdered Beverage Dispensers Page 21...
-
Page 22: Wiring Diagram
PIC-1-DC and PSD-1Wiring Diagram 120V and 120/240V (Q Models) Crathco Powdered Beverage Dispensers Page 22... - Page 23 PIC-2 and PIC-3 Wiring Diagram 120V and 120/240V (Q Models) Crathco Powdered Beverage Dispensers Page 23...
- Page 24 PIC-2J and PIC-3J Wiring Diagram 100 and 200 V Crathco Powdered Beverage Dispensers Page 24...
- Page 25 PIC-2-DC and PIC-3-DC Wiring Diagram 120V and 120/240V (Q Models) ( 3 Portions per head ) Crathco Powdered Beverage Dispensers Page 25...
-
Page 26: Wiring Diagram
PIC-2-DCJ and PIC-3-DCJ Wiring Diagram 100V & 200V ( 3 Portions per head ) Crathco Powdered Beverage Dispensers Page 26...
Need help?
Do you have a question about the PIC-33A Series and is the answer not in the manual?
Questions and answers