Operator Manual Simplicity Bubbler ™ Crathco Cold Beverage Dispensers ® Model CS-2E-16 Model CS-2D-16 (cULus certification applies only to United States and Canada models.) Table of Contents Safety Information......2 Product Preparation & Use...7 Specifications.........3 Daily Cleaning .......8 Installation and Set-Up....4 Basic Machine Parts ....11...
NOTICE/ AVIS/ AVISO Observe machine voltage configuration. Do not apply improper voltage to machine or damage to machine will occur. Do not use extension cord. Do not operate the appliance below 1.7°C (35°F) or above 40°C (104°F). Crathco ® Simplicity Bubbler...
CS-3D-22-S (1) 4.75 gallon (18L) bowl, 25.5” x 20.4” x 17.7” 230V / 50/60 HZ / 4A NSF, CE (2) 2.4 gallon (9L) bowls, 65 cm x 52 cm x 45 cm spray model. Crathco ® Simplicity Bubbler...
2. Children should be supervised to ensure that they do not play with the appliance. 3. This appliance is only to be installed in locations where it can be overseen by trained personnel. Crathco ® Simplicity Bubbler...
Machine must be OFF. bowl. Place drip tray cover on drip tray. Install drip tray. Install handle. Flip out support bracket for drip tray. Turn power “on”. Mix product in clean container. Install bowl cover. Fill bowl with product. Crathco ® Simplicity Bubbler...
Install handle. Flip out support bracket Install drip tray and cover. Install spray tube to fit for drip tray. with Pump cover. Mix product in clean container. Install bowl cover. Turn power “on”. Fill bowl with product. Crathco ® Simplicity Bubbler...
3. Install lid and turn on main power switch. 4. 25~30° C (77~86° F) ambient temperature is suitable for the operation. 5. This machine maintains beverage temperature of 1~5° C (34~41° F). 6. The dispenser is not for dispensing potentially hazardous beverage. Crathco ® Simplicity Bubbler...
Rotate support brackets for drip tray. NOTICE/ AVIS/ AVISO: FRAGILE! Press release latch on front of the Remove bowl cover. Do not drop. machine before removing the bowl. Remove bowl gasket. Remove mixing impeller. Remove valve with seal. Crathco ® Simplicity Bubbler...
Page 9
AVOID LEAKS DUE TO SEALED SURFACE BEING DAMAGED. NOTICE/ AVIS/ AVISO: The appliance is not suitable for installation in an area where a water jet could be used. The appliance must not be cleaned by water jet. Crathco ® Simplicity Bubbler...
.75mm surface is (0.03 inch) worn. thick. Impeller and/or axle worn? Replace worn parts. Pump motor magnet needs adjustment? See routine maintenance. ( Call for service. Impeller assembled correctly? Crathco ® Simplicity Bubbler...
Page 13
Dirty condenser filter and condenser? Clean condenser or ( call for service. Impeller does not spin. Faulty No product agitation? Operator Manual Simplicity ™ Bubbler Crathco ® Cold Beverage Dispensers pump motor? See previous page. ( Call for service. Model CS-2E-16 Model CS-2D-16 Table of Contents Safety Information......2...
Page 14
3. The appliance is suitable for liquid juice concentrate and beverage mixing powder. 4. Access to the service area is restricted to persons having knowledge and practical experience of the appliance, in particular as far as safety and hygiene are concerned. Crathco ® Simplicity Bubbler...
Page 15
(USA & Canada only) (Monday through Friday 8 AM - 6 PM EST). Please have the model and serial number ready so that accurate information can be given. Prior authorization must be obtained from Grindmaster-Cecilware for all warranty claims. Grindmaster-Cecilware provides the industry’s BEST warranty. Visit our website at GMCW.com for warranty terms and conditions. Crathco ® Simplicity Bubbler...
Need help?
Do you have a question about the Simplicity CS-2E-16 and is the answer not in the manual?
Questions and answers