Control Pad Features; Temperature Visual Display; For A Silent Control Panel - Kenmore 790.9760 series, 790.9763 series Use & Care Manual

Control Pad Features

READ THE INSTRUCTIONS CAREFULLY BEFORE USING THE OVEN. For satisfactory use of your oven, become familiar
with the various features and functions of the oven as described below. Detailed instructions for each feature and function
follow later in this Use & Care Guide.
NOTICE: The instructions contained in this document only refer to the upper oven operations. These instructions can also
be applied to the lower oven by selecting the same functions (except convection bake) on the right hand side of the
control panel.
1 2
5
4
8
7
Oven Control Keypads
1. Bake - Used to start normal bake function.
2. Broil - Used to select the broil function.
3. Warm & Hold - Used to set the Warm & Hold function.
4. Cook Time- Used to enter the length of the cook time
desired.
5. Delay Start - Used to set the desired start time for
baking. May be used with COOK TIME to program a
delayed timed bake or clean cycle.
6. Self Clean or Flex Clean (some models) - Used to set a
2 to 4 hours Self-Clean cycle.
7. Conv Bake - Used to select the Convection feature
(available with the upper oven only)
8. Oven Light - Used to turn oven light ON and OFF.

Temperature Visual Display

Your oven is equipped with a temperature visual display. When a cooking mode is set, the actual temperature will be
shown in the display and will rise as the unit preheat. When the unit has reached its target temperature, a chime will
sound to remind you to place the food in the oven. This feature will be active with the modes: BAKE and CONV BAKE
(upper oven only).

For a silent control panel:

The DELAY START pad controls the Silent Control Panel feature. The Silent Control Panel feature allows the oven control to
be operated without sounds or beeps whenever necessary. If desired the control can be programmed for silent operation
and later returned to operating with all the normal sounds and beeps.
To change control from normal sound operation to silent control operation
Press and hold DELAY START pad for 6 seconds. A beep will sound, "-- --" will appear, "DELAY" will flash in the display.
1.
After 6 seconds, a beep will sound and "SP" (speaker) or "- -" will appear in the display.
pad to switch between normal sound operation and silent operation mode. If "SP" appears, the control
2. Press or
will operate with normal sounds and beeps. If "- -" appears, the control is in the silent operation mode.
3. Wait 5 seconds to accept the change or press STOP pad to reject the change.
Note: The control will always beep at the end of a minute timer and will beep when a set temperature has been reached,
even if the control is set to silent operation.
3
6
9
10 11 13
12
9. STOP - Used to cancel any oven function previously
entered except Clock and Timer. Also used to lockout
oven functions and door.
10. Timer Set/Off - Used to set or cancel Timer. The minute
timer does not start or stop cooking.
11. Add 1 Minute - Used to add additional minutes to
Timer.
12. Warm & Ready Zone - Used to set the Warm & Ready
Zone feature.
13. Up and Down Arrow - Used along with the function
pads to select oven temperature, cook time, start time
(when programming an automatic start time), time of
day, clean time and minute timer.
14. Clock Set - Used to set the time of day.
12
1 2 3
5 6
4
9 8
14