When Automatic Presetting Of Channels Are Finished; Channel Caption (Station Identifier); To Add Or Erase Channels - Hitachi VTUX6430A Owner's Manual

Note: Your VCR is capable of receiving 68 broadcast TV channels (vhf 2 - 13, uhf 14 - 69) and cable channels
(CA TV I - 125). In some areas channels cannot be received when CATV1 is selected. In this case, select CATV2
in the receiving setup.

When automatic presetting of channels are finished

Press the CH (channel) button (or numbered buttons) to check the channels you can receive.
Note: If no channels have been set or a clear picture does not appear, check the antenna or cable connection.

Channel Caption (Station Identifier)

When your VCR is receiving a channel caption signal that is transmitted by a local broadcasting station together
with a TV program, a station identifier is displayed on the TV screen.

To add or erase channels

The auto channel set procedure may memorize channels that are blank, have snowy pictures, or
interference. You may skip these channels by erasing them. Very weak stations might not be
memorized at all. You may receive these stations by adding them.
1 Press the GUIDE button.
The main on-screen menu will appear on the TV screen.
2 Press the cursor button to select the SETUP option, and then press the ENTER button.
3 Press the cursor button to select the channel, and then press the ENTER button.
4 Use the cursor buttons to select CH LIST <ADD/ERASE>, and then press the ENTER button.