Electronic Oven Control; Displays; Start; Off/Cancel - Whirlpool GSC308 Use & Care Manual

F
A. Lower oven display
B. Number pads
C. Upper oven display
D. Timer

Displays

When power is first supplied to the appliance, everything on both
displays will light up for 5 seconds. Then, "PF id = 27" or "PF id =
30" will appear on the lower oven display. Touch OFF/CANCEL to
clear display.
If "PF id = 27" or "PF id = 30" appears at any other time, a power
failure has occurred. Touch OFF/CANCEL and reset the clock if
needed.
Lower Oven Display
When the lower oven is in use, this display shows the lower oven
temperature, heat source(s) and start time.
During lower oven Timed Cooking, this display also shows a
vertical bar and minute time countdown and the stop time (if
entered).
If "Err" appears on the display, an invalid pad was touched.
Touch OFF/CANCEL and retry the entry.
When the lower oven is not in use, this display is blank.
Upper Oven Display
When the upper oven is in use, this display shows the upper oven
heat source(s), cooking power, quantities, weights and/or help
prompts.
If "RETRY" flashes on the display for 1 second, an invalid pad
was touched. Retry the entry.
When the upper oven is not in use, this display shows the time of
day or Timer countdown.
The Start pad begins any oven function except the Timer. If the
Start pad is not pressed within 5 seconds after pressing a pad,
"START?" will appear on the oven display as a reminder. If the
Start pad is not pressed within 4 minutes after pressing a pad,
the oven display will return to the time of day mode and the
programmed function will be canceled.

ELECTRONIC OVEN CONTROL

A
G H I
E. Clock
F. Lower oven selectors
G. Timed cooking
H. Auto clean

Start

B
J
I. Oven light
J. Lower oven start (control lock) and lower
oven off/cancel
K. Upper oven controls
(see separate Use and Care Guide)
The lower oven Off/Cancel pad stops any lower oven function
except for the Clock, Timer and Control Lock.
The cooling fan may continue to operate even after the lower
oven Off/Cancel is pressed depending on the oven temperature.
This is a 12-hour clock and does not show a.m. or p.m.
To Set:
Before setting, make sure the ovens, Timer and Timed Cooking
are off.
1. Press CLOCK.
2. Press the number pads to set the time of day.
3. Press CLOCK or START.
To remove the time of day from the display: Press and hold
CLOCK for 5 seconds. Repeat to return the time of day to the
display. The time should not have to be reset.
Tones are audible signals, indicating the following:
One tone
Valid pad touch
Oven is preheated
Function has been entered
Three tones
Invalid pad touch
Four tones
End of cycle
Reminder, repeating each minute after the end-of-cycle tones
D
C E
K

Off/Cancel

Clock

Tones

5