I Mounting The Router - Ryobi RT601W Operator's Manual

WARNING:
Always unplug router and remove router bits before
mounting to router table. Remove the fence, the
insert, the featherboards and the miter guide from the
tabletop before mounting the router.
There are two methods for attaching routers to router
table. The table will accept routers with bases up to 7" in
diameter. See chart below to determine whether your
router will mount directly to the table (Method I.). It is also
possible to attach the router to router table with the clamp-
ing system (Method II.).
Brand Model #
R160K, R160V
R161K, R161KT
Ryobi ®
R162K, R165
R180, R180PL
693LRPK
694VK, 892
Porter Cable ®
893PK, 895PK
1001, 8931
Milwaukee ®
Hitachi ®
Black & Decker ®
DeWalt ®
1810, 1815
1820, 1823
Skil ®
1825, 1835
MOUNTING THE ROUTER
Adapter
hole pattern
A/AB
R1801M
690, 691
D
9690LR
26941
5615-21
D
5616-21
5619-20
D
KM12VC
F
7612
F
DW 610
D
DW 616
E
1845-02
Brand
Craftsman ®
Note: F hole pattern present in adapter plate only.
See Figure 15
NOTE: If your router is not one of those listed in the chart
above, place the drop in plate on the router base plate and
rotate until the holes in the plates are aligned. When the
hole patterns line up, the mounting scheme has been
identified.
NOTE: For additional mounting with the drop in plate
see page 18.
15
Adapter
Model #
hole pattern
17504, 17505
17506, 17511
17515, 17528
17533, 26834
27500, 27510
27511
E
A
Fig. 15