Your new long miter/rip fence kit includes a 41 in. extension
rail, plus the necessary brackets, and connecting hardware
required to assemble a long miter fence and attach it to the
sliding miter table of your BT3000/BT3100/BT3100-1 table
saw. It also includes connectors and hardware required for
attaching a long rip fence to your saw.
Note: When used as a long miter fence this kit temporarily
replaces the miter fence supplied with your saw. When used
as a long rip fence it attaches to the rip fence supplied with
your saw.
MITER/RIP FENCE
RAIL
WORK SUPPORT
BRACKET
KNOB BOLT
BRACKET (RIGHT
POSITIVE STOP)
Miter/Rip Fence Rail .........................................................1
Bracket (Support and Left Positive Stop)..........................2
Saw Gage.........................................................................2
Knob Bolt .........................................................................1
Knob Nut ..........................................................................1
T-Nut ................................................................................6
Square Head Bolt (1/2 in.) ................................................1
5/16 in. Washer.................................................................6
Bracket (Right Positive Stop) ............................................1
UNPACKING
SAW GAGE
BRACKET (SUPPORT AND
LEFT POSITIVE STOP)
LOOSE PARTS
Remove the parts from the box. Make sure that all items
listed in the loose parts list are included.
Inspect all parts carefully to make sure no breakage or
damage occured during shipping.
If any parts are damaged or missing, please call 1-800-
525-2579 for assistance.
WARNING:
If any parts are missing do not assemble the kit until the
missing parts are replaced. Failure to do so could result
in serious personal injury
SQUARE HEAD BOLT (1/2 in.)
LOCATOR
PIN
5/16 in.
WASHER
HEX BOLT
(7/8 in.)
KNOB NUT
1/4 in. Washer...................................................................1
Plastite Screw...................................................................2
Work Support Bracket ......................................................1
Hex Bolt (7/8 in.)...............................................................1
Miter Indicator...................................................................1
Locator Pin .......................................................................1
Connector .........................................................................2
Hex Bolt (1/2 in.)...............................................................4
4
HEX BOLT (1/2 in.)
CONNECTOR
PLASTITE SCREW
T-NUT
MITER
INDICATOR
SAW GAGE
1/4 in.
WASHER
Fig. 1