Unpacking; Assembly - Ryobi Jig Saw Operator's Manual

This tool has been shipped completely assembled except
for the blade.
n Carefully remove the tool and accessories from the
box.
n Make sure that all items listed in the packing list are
included.
n Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
n Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
n If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
Do not connect to power supply until assembly is complete.
Failure to comply could result in accidental starting and
possible serious personal injury.
TO INSTALL JIG SAW BLADES
See Figure 2.
n Unplug your saw.
n Lift the clamping lever on the rapid-change blade clamp
until it stops.
n Holding the clamping lever up, insert the saw blade as
far as possible into the slot in the saw bar.
n Check to make sure the back of the saw blade is centered
in the groove of the roller guide.
n Release the clamping lever. Make sure the blade is
securely in place.
DUST PICK-UP FEATURE
See Figure 3.
For dust pick-up operation, a vacuum attachment has been
provided with the saw. It attaches to the saw base.
To Install:
n Unplug the saw.
n Slide the vacuum attachment into the curved area at the
rear of the saw base until it snaps into place.
n Attach vacuum attachment to a 1-1/4 in. vacuum hose.
n Connect vacuum hose to cleaner.
To Remove:
n Unplug the saw.
n Remove the vacuum attachment by pulling attachment
from base.

UNPACKING

PACKING LIST
Variable Speed Orbital Jig Saw
Blades (2)
Vacuum Attachment
Edge Guide
Case
Operator's Manual
Warranty Registration Card
WARNING:
If any parts are missing do not operate your tool until the
missing parts are replaced. Failure to do so could result
in possible serious personal injury.

ASSEMBLY

CLAMPING
LEVER
10
SAW BLADE
Fig. 2
VACUUM ATTACHMENT
Fig. 3