Recording Procedure - Sony DSR-DR1000 Operating Instructions Manual

• When, in 4-channel mode, analog audio is selected
for all four channels (channels 1/2 and 3/4), the same
analog audio signals are recorded on channels 1 and
3 and on channels 2 and 4, respectively.
7
When manually adjusting audio input levels, with the
VARIABLE switch on the front panel set to REC, use
the REC/PB LEVEL control knob for each channel to
adjust the audio input level. Watching the audio level
meter in E-E mode, adjust the level so that the meter
does not indicate higher values than 0 dB when the
audio signal is at its maximum. When the level
exceeds 0 dB, the OVER indicator lights.
When recording at reference level
When the VARIABLE switch on the front panel is set
to PRESET, recording is carried out at the preset
reference level.
Reference level setting
The factory-preset reference level for analog audio
input is −20 dB (DSR-DR1000P) or −18 dB (DSR-
DR1000P). This setting can be changed using the
LEVEL SELECT menu item (see page 73).

Recording Procedure

This section describes the procedure to perform normal
recording on this unit, showing an example session in
which playback signals coming from a player VCR will be
recorded on the tape loaded in the unit.
Recorder
(this unit)
Control mode
selector
Player
(DSR-1500A)
Note
When controlling this unit from an editing control unit
connected to the REMOTE IN (R) connector of this unit,
set the Control mode selector to REMOTE, turning the
REMOTE indicator on. When not, set the switch to
LOCAL, turning the indicator off.
If the REC INHI indicator lights:
The REC INHIBIT menu item (see page 67) is set to ON
(recording inhibited). Set it to OFF.
1
Hold down the REC button and press the PLAY
button on the recorder.
This unit starts recording.
2
Press the PLAY button on the player.
The player starts the playback operation.
Caution
Once you have started recording, you cannot change
the audio mode or recording format.
To perform the following operations
Operation
Stop recording.
1
dB OVER dB OVER INPUT CL REC INHI
U-BIT SERVO
0 0 VIDEO AUDIO
V:SDTI COMPOSITE
CH-1 1/2 CH-2 3/4 TC COUNTER NO EDIT REPEAT
SDTI S VIDEO ANALOG ANALOG
-12 -12
i.LINK Y-R,B AES/EBU AES/EBU
-20 -20
SDI SG SDI SG SDI SG
OUTPUT
-30 -30
VIDEO AUDIO
-40 -40
SDI COMPOSITE CH 1/2 HOURS MINUTES SECONDS FRAMES
-60 -60
SDTI S VIDEO CH 3/4 PB F REC MODE VITC REMOTE
S
CH- 1 3 CH- 2 4 9P i.LINK
Y-R,B 48K 44.1K 32K 2CH 4CH EDIT MODE
REW PLAY F FWD STOP REC
2
Do this:
Press the STOP button.
Recording
37