ENSONIQ DP/4+ Reference Manual page 87

06 — Phaser Feedback
Controls the amount of feedback applied to the left and right channel phaser. The sign of the
value determines the polarity of the feedback.
07 — Phaser Notch Depth
Controls the depth of the notches created by the phasing. Deep notches occur in the phased
spectrum when the parameter is set to 99. When this parameter is set to +00, there exists no
phasing (i.e. notches), but there is a doppler effect with higher LFO rates.
08 — Left/Right LFO
Determines whether the phaser on the left and right channels is modulating in or out-of phase.
09 — Phaser Sample & Hold Rate
Controls the sample rate of a sample and hold network applied to the LFO within the phaser.
When in hold, the effect will be to create momentarily fixed notches within the frequency
spectrum (if the notch depth is not +00). A setting of 001 will have the largest space between
samples. Higher values will increase the number of holds per second, making the phasing flow
more smoothly. The sample and hold function can be turned off.
10 — Phaser Left Delay Time
This parameter sets the delay time for the left side. This is the "ping."
11 — Phaser Right Delay Time
Controls the feed forward delay time for the right side. This is the "pong."
12 — Phaser Delay Feedback
Controls the feedback amount for the delay effect. The sign of the value determines the polarity
of the feedback. A value of +00 will eliminate the delay effect. This parameter also controls the
feed forward level (see diagram).
13 — Mod1 Source
14 — Mod1 Destination
15 — Mod1 Param Range Min 19 — Mod2 Param Range Min
16 — Mod1 Param Range Max20 — Mod2 Param Range Max
See the descriptions under the Algorithm Modulators, found earlier in this section.
ENSONIQ DP/4+ Reference Manual
Range: -99 to +99
Range: -99 to +99
Range: Out-of-Phase or In-Phase
Range: Off, 001 to 100
Range: 0 to 1600 ms
Range: 0 to 1600 ms
Range: -99 to +99
17 — Mod2 Source
18 — Mod2 Destination
Section 2 — Algorithms
71