ENSONIQ DP/4+ Reference Manual page 118

Section 2 — Algorithms
01 — Mix
02 — Volume
See the descriptions under the Mix and Volume Parameters, in the beginning of this section. For
this algorithm, we recommend a mix setting of 99.
03 — Vocal Pos
This is used to compensate for panning in the original recorded vocal.
04 — L/R Delay
This makes up for any slight delay that may exist between the left and right channels due to
idiosyncrasies of the recording or playback process.
05 — Bass Level
Controls the output level of the lowpass filters. This signal goes directly to the main outputs.
06 — Treble Level
Controls the output level of the highpass filters. This signal goes directly to the main outputs.
07 — Mid Level
Controls the output level of the bandpass filters. As shown in the diagram, the output of the
bandpass filters goes to the cancellation circuit.
08 — Bass Fc
Determines the cutoff frequency of the lowpass filters. If this parameter is set too high, some
vocal components may begin to leak into the output of the effect.
09 — Trebl Fc
Determines the cutoff frequency of the highpass filters. If this parameter is set too low, some
vocal components may begin to leak into the output of the effect.
10 — Mid Fc
Determines the cutoff frequency of the bandpass filters.
11 — BW
This determines the bandwidth of the bandpass filters.
12 — Mod1 Source
13 — Mod1 Destination
14 — Mod1 Param Range Min 18 — Mod2 Param Range Min
15 — Mod1 Param Range Max19 — Mod2 Param Range Max
See the descriptions under the Algorithm Modulators earlier in this section.
102
Range: -127 to +127
Range: -127 to +127
Range: 00 to 99
Range: 00 to 99
Range: 00 to 99
Range: 80 to 1000 Hz
Range: 1000 to 16000 Hz
Range: 80 to 16000 Hz
Range: 80 to 16000 Hz
16 — Mod2 Source
17 — Mod2 Destination
ENSONIQ DP/4+ Reference Manual