Table of Contents
Advertisement
OL indicators and level meters
The audio levels of this unit can be checked using the INPUT A/B OL
indicators and the level meters on the display.
The level meters allow the signal levels to be checked, and they can also be
used to confirm whether signals are being input into the unit. For example,
if the
and
level meters are moving a signal is being input into the unit
even if you cannot hear anything when you are monitoring with headphones
or an external monitoring system (powered monitor speakers or an amplifier
and speakers). In this case, something other than this unit is probably the
reason that sound is not being output.
As shown below, if a "–" appears at the top of a level meter, the input is
overloading (these "–" indicators will automatically disappear after a while). In
this case, the sound might be distorted, so lower the level until the "–" stops
appearing.
If an OL indicator lights, the input source signal could be too loud or the
LEVEL knob set too high.
If the OL indicator lights even if the LEVEL knob is set to MIN, the input
source signal is too high, so lower the volume on the input source.
Overload indicators
8 Input level meters (A/B)
The
and
level meters on the display show the input levels of this unit's
INPUT A and INPUT B.
Use the INPUT A/B LEVEL knobs, INPUT SETTING screen settings and the
output volume controls of the input sound source to adjust the levels.
NOTE
If an INPUT A/B OL indicator lights even though the INPUT A/B level
meters shows a suitable level, the input signal is too strong and the sound
is distorted. Lower the output volume of the input sound source.
8 TRACK level meters (1–4)
These meters show either playback signal levels or the track input signal
levels, depending on the operation status, as shown below.
REC indicator
Transport status
Unlit
Playing back
Playing back
Blinking
(recording standby)
Stopped
Lit (recording)
Recording
NOTE
When the playback signal is shown, the level of the recorded signal of the
track is shown, so the level shown by the meters cannot be changed. When
the input signal is being shown, the INPUT A/B LEVEL knobs can change
the levels shown by the level meters.
8 Stereo level meters (L/R)
These show the stereo bus output level of this unit. Adjust the output level
with the MASTER LEVEL knob.
NOTE
When an input source is a built-in mic, if the REC indicator is not lit on
a track that has the built-in mic as its recording source, the input sound
cannot be heard.
6 – Basic Recording
Signals shown
by level meters
Track playback
Track playback
Track input
Track input
TASCAM DP-006
53
Advertisement
Table of Contents
