Hard Drive - Dell Latitude D500 Service Manual

Back to Contents Page

Hard Drive

Dell™ Latitude™ D500 Service Manual
CAUTION: If you remove the hard drive from the computer when the drive is hot, do not touch the metal housing of the hard drive.
CAUTION: Before working inside your computer, read the safety instructions in your System Information Guide.
NOTICE: To prevent data loss, shut down your computerbefore removing the hard drive. Do not remove the hard drive while the computer is on, in
standby mode, or in hibernate mode.
NOTICE: Hard drives are extremely fragile; even a slight bump can damage the drive.
NOTE: Dell does not guarantee compatibility or provide support for hard drives from sources other than Dell.
1. Follow the instructions in "Preparing to Work Inside the
2. Turn the computer over. Use a standard #1 Phillips screwdriver to remove the M2.5 x 5-mm screw.
1 M2.5 x 5-mm screw
NOTICE: If you do not open the display before you remove your hard drive, you might permanently scratch your display.
3. Open the display approximately 0.5 inch.
NOTICE: When the hard drive is not in the computer, store it in protective antistatic packaging. See "Protecting Against Electrostatic Discharge" in your
System Information Guide.
4. Slide the hard drive out of the computer.
5. Remove the new drive from its packaging.
Save the original packaging to use when storing or shipping the hard drive.
Computer."