Compaq TFT5010 User Manual page 11

Removing the Monitor Base
Before you can mount the monitor onto a swing arm or other mounting
fixture, you must remove the monitor from the base.
CAUTION:
sure the monitor is turned off and the power and signal
cables are both disconnected.
To remove the monitor from the base, complete the following steps:
1. Lay the front bezel down on a soft area to prevent it from
getting scratched, defaced, or broken.
2. Remove the cover 1 from the monitor base by placing your
fingers in the opening on the bottom of the base and pulling
upward, then pulling out to remove the cover.
3. Remove the back panel 2 from the monitor by pushing the
bottom tabs upward and pulling out to remove the back panel.
4. Disconnect and remove the signal and power cables from the
back of the monitor.
5. Remove the four screws 3 as shown in the following
illustration.
Before beginning to disassemble the monitor, be
English 9