ZyXEL Communications P-660R-Tx v3 Series Support Notes page 19

Key Settings
Field Description
Login ACS Configure this part of the screen to log into the management server.
CWMP Select Activated to allow the ZyXEL Device to be managed by a
management server or select Deactivated to not allow the ZyXEL Device to
be managed by a management server.
URL Type in the IP address or domain name of the management server.
User Name Type a user name of up to xxx printable characters found on an
English-language keyboard.
Password Type a password of up to xxx printable characters found on an
English-language keyboard. Spaces are not allowed.
Connection Use this part of the screen to allow the management server to connect to the
Request ZyXEL Device after a successful login.
Path This is the part for verification from ACS to ZyXEL Device. It can be
considered as CPE‟s URL. When ACS initialize a session, it will connect
with CPE basing on this part.
Port The default port for access to the ZyXEL Device from the management
server is the HTTP port, port 80. If you change it, make sure it does not
conflict with another port on your network and it is recommended to use a
port number above 1024 (not a commonly used port). The management
server should use this port to connect to the ZyXEL Device. You may need
to alter your firewall or NAT port forwarding rules if they were already
configured.
Periodic Select Activated to have the ZyXEL Device periodically send information to
Inform the management server (recommended if CWMP is enabled) or select
Deactivated to not have the ZyXEL Device periodically send information to
the management server
Interval Enter a value between 1 and 86400 seconds.
All contents copyright © 2008 ZyXEL Communications Corporation.
P-660R-Tx v3 Series Support Notes
19