Advertisement
Whenthe control knobis turned ON, gas will flow intothe burner. The solid state igniter
will click as long as the knob is in the Lite position. (Note: All burner igniters will spark
regardlessof which burner is being operatedwhen a knob isturned to the Iite position.)
A properly adjusted burner with clean ports will light within a few seconds. On natural
gas, the flame will be blue with a deeper blue inner core. There should be no trace of
yellow in theflame. A yellowflame indicatesan impropermixtureof air/gas. This wastes
fuel, so havea servicemanadjust the mixtureif a yellow flame occurs. On LP gas, some
yellow tipping is acceptable. This is normal and adjustment is not necessary.
The infinite surface controls provide flexibility in heat setting selection. (See page 7,)
In case of prolonged powerfailure, youcan manuallylight the surfaceburner by holding
a lightedmatchnearthe burnerportsand slowlyturningthe controlknobcounterclockwise
(after depressing) to the LJte setting.
CAI,ITION: When lightingthe surface burner, be sure all of the controlsare in the OFF
position. Strike the matchfirst and hold it in position beforeturning the knobto the Lite
position.
Note: Becauseyour overhead hood fan is electricit will notwork during a power failure
so smoke and condensationcan gather.
COUNTERCLO£;KWlSE
t TO,NCREASE
_LAME
The Lo setting should produce a stable flame
_
_1 SLzE
when turning the knob from Hi to Io.
The
CLOCKW,SE.IIII A
TO REDUCE
flame should extend to the outer edge of the
FLAME
SIZE
lip of theburner capon the Lo settingand must
be stable on all ports on Lo setting.
VALV
W
To adjust" Operate burner on Hi for about 5
STEM
,
,
minutes to preheat burner cap. Turn knob
back to Lo; remove knob, and insert a small
screwdriver into the center of the valve stem.
Adjust flame size by turningadjustment screw
in eitherdirection while holdingthe valve stem
securely.
Flame must be of sufficientsize to be stable on all burner ports. If flame adjustment is
needed,adjust ONLY on the Lo setting. Never adjust flame size on a higher setting.
Note: All gas adjustments should be done by a qualified servicer only.
6
Advertisement
