Table of Contents
Advertisement
Linksys
NOTE:
A pop-up confirmation message will appear to remind you to log
in to the user Web GUI with the new device IP address . Click OK to
confirm the change, or click Cancel to leave without applying the
changes .
Multiple Subnet Setting (IPv4 only)
This function enables users to add IP segments that differ from the router
network segment to the multi-net segment configuration . The Internet will
then be directly accessible .
Click the button to add a new VLAN . The router
Add a VLAN:
supports up to 5 VLANs . In other words, you can
add another 4 new VLANs .
1 .Click the button and enter a LAN IP address and
Add a Subnet for
a Subnet Mask . The IP address and subnet mask
Outbound NATing:
appear in the list . Repeat this step as needed to add
more subnets .
2 . You can also modify an existing subnet
3 .Click the trash can icon to delete the subnet
WAN Setting/ DMZ Setting
(Internet connection & DMZ)
To set the WAN port to link to the Internet, refer to the configuration information
provided by your ISP (Internet Service Provider) . The WAN setting table shows
WAN and DMZ ports of the router . You can configure the WAN/DMZ port for
use as a DMZ .
WAN Setting
NOTE:
Remember to click Save before leaving the page . You can also click
Cancel to undo the changes .
An indication of which port is connected .
Interface:
WAN
Obtain an IP automatically, Static IP, PPPoE (Point-
to-Point Protocol over Ethernet), PPTP (Point-to-
Connection Type:
Point Tunneling Protocol) and Transparent Bridge .
A modification in an advanced configuration . Click
Config.:
Edit to enter the advanced configuration page .
Setup
10
Advertisement
Table of Contents
