Figure 5-10: Network Settings Screen; Figure 5-11: Ip Settings Screen - Cisco LINKSYS WVC54GC User Manual

Compact Wireless-G Internet Video Camera
11. The Network Settings screen will appear. Select the setting appropriate for your network.
Automatic Configuration-DHCP. If your network has a DHCP server, such as a router with DHCP enabled,
click the Automatic Configuration-DHCP radio button.
Static IP address. If you need to assign a static IP address to the Camera, keep the default setting, Static IP
address.
Then click the Next button.
NOTE: If you are setting up the Camera and you will be using it behind a router, in most
cases, you can use the IP address of the router as the default gateway and primary DNS,
otherwise you need to contact your ISP.
12. If you selected Automatic Configuration-DHCP in step 12, then proceed to step 14.
If you selected Static IP Address, then the IP Settings screen will appear. Enter an IP Address, Subnet Mask,
and Default Gateway appropriate for your network. You must specify an IP Address and Subnet Mask on this
screen. If you are unsure about the Default Gateway, it is better to leave this field blank. Then complete the
Primary DNS and/or Secondary DNS fields. Click the Next button.
IP Address. Enter the IP Address of the Camera.
Subnet Mask. Enter the Subnet Mask of the Camera.
Default Gateway. Enter the IP address of the Default Gateway. If you are not sure, leave this field blank.
Primary and Secondary DNS. Enter the IP address of your primary and secondary DNS server. You must
enter at least one DNS address, which can be obtained from your ISP.
Chapter 5: Setting up and Mounting the Compact Wireless-G Internet Video Camera
Setup Wizard

Figure 5-10: Network Settings Screen

Figure 5-11: IP Settings Screen

14