Connect The Router - Linksys WRT300N Quick Installation Manual

There are two ways to configure the Router. Choose one of the following:
• Run the Setup CD-ROM - Insert the Setup CD-ROM into the CD-ROM
drive, and follow the on-screen instructions.
• Use this Quick Installation Guide - If you wish, you can use the Router's
Web-based Utility. Proceed to Step 1 of this Quick Installation.
1

Connect the Router

A
Make sure that all of your
hardware is powered off,
including the broadband
modem and PCs.
B
Connect your broadband
modem's Ethernet cable to
the Router's Internet port.
C
Connect one end of an
Ethernet network cable to one
of the numbered ports on the
back of the Router. Connect
the other end to an Ethernet
port on a network device, e.g.,
a PC, print server, or switch.
Repeat this step to connect
more PCs or other network
devices to the Router.
D
Power on the broadband
modem.
2
B
C