CEN-TECH 60703 Owner's Manual page 7

Charging the Power Pack
WARNING! Always charge on a non-flammable surface.
1. Press and hold the Battery Test Button on the
front of the unit to check the battery power level.
a. 13-15 volts is ready for use.
b. 12 volts needs to be charged.
c. Less than 12 volts should be
charged immediately.
2. Turn the Clamp Power Switch on front
of unit to the OFF position.
3. Plug the 120VAC Adapter into a 2 or
3-prong outlet. (See Figure B.)
Figure B
4. Plug the Adapter cord into the Charging
Input on the front of the unit.
Item 60703 For technical questions, please call 1-800-444-3353.
5. Allow the time needed to charge,
periodically checking the Voltmeter.
Note: Before initial use, completely charge the Power
Pack as indicated for Initial Charge. (See Figure C.)
AC Charge Time
Initial Charge:
48 hours
Recharge:
34 hours
Figure C
NOTE: FAILURE TO RECHARGE POWER
PACK WILL VOID WARRANTY.
6. When the Power Pack is fully charged, unplug the
Adapter from the outlet and the Power Pack.
7. Recharge for length of time as indicated
for Recharge: (See Figure C.)
a. When voltage drops to 12 volts.
b. After each Jump-Start..
c. Once a month.
8. The Charging Indicator light will illuminate when
the unit is charging. The Charging Indicator
light will not turn off when the charging is
complete. The Voltmeter must be checked
periodically when charging and the Power Pack
must be unplugged when the unit is fully charged.
DO NOT EXCEED MAXIMUM CHARGING TIME.
Page 7