Preparation - Panasonic CQ-C8401W Manual

Preparation

When the power is switched on for the first time, a
demonstration message appears on the display. Press
[DISP] to change to regular mode.
1
Set your car's ignition switch to the ACC
or On position.
The demonstration screen appears.
2
Press [DISP: DISPLAY].
The demonstration screen is cancelled, and no more
appears.
Preparation Before Initial Use
Pull the insulation film out
from the backside of
remote control gently.
Insulation film
Battery Replacement
q Remove the battery holder
Tough pointed object
with the remote control unit
placed on a flat surface.
q Stick your thumbnail into
the groove, and push the
holder in the direction of
the arrow, and at the
same time.
w Pull it out in the direction
of the arrow using a
Back side
tough pointed object.
w Put a battery in the case
with (+) side facing up.
e Put the case back.
10
CQ-C8401W/C7401W
SRC SQ CQ-C8401W
Note: If you would like to turn on the power and make
the demonstration message appear, hold down [SRC]
(PWR: POWER) for 4 sec. or more.
Warning
Keep batteries and insulation film out of reach of
infants. If an infant ingests a battery, please seek
immediate medical attention.
Cautions
¡Remove and dispose of an old battery immediately.
¡Do not disassemble, heat or short a battery. Do not
throw a battery into a fire or water.
¡Follow local regulations when disposing of a battery.
¡Improper use of a battery may cause overheating, an
explosion or ignition, resulting in injury or a fire.
Note: Battery Information:
Battery Type: Panasonic lithium battery (CR2025)
(Included in the remote control)
w
Battery Life: Approximately 6 months under normal use
q
(at room temperature)
2
3
The following functions are activated when the Security
Function is ON. (a page 31)
¡ The security indicator lights up when removing the
face plate.
Security Indicator
You may need to set the following depending on the
devices to be connected.
Using Subwoofer
¡
Subwoofer level adjustment (a page 30)
¡ Subwoofer low pass filter (a page 30)
Note: Adjust the clock when "ADJUST" appears on the
display.
1
Press [MENU] to display the menu
display.
For using the remote control, hold down [SEL]
(MENU) for 2 sec. or more.
2
Press []] or [[] to display the
DISPLAY menu.
3
Press [ { ] to select "CLOCK ADJ".
4
Press [BAND] (SET) to confirm the
display.
¡ The alarm sounds and the message appears on the
screen to warn you to remove the face plate at ACC
off.
5
Adjust the setting value.
[[]
: Adjusting minutes
[]] : Adjusting hours
[ ]
} : Forward
[ { ] : Backward
6
Press [BAND] (SET) to confirm the
adjustment.
Note: For cancellation of clock adjustment, press [DISP].
7
Press [MENU].
For using the remote control, hold down [SEL]
(MENU) for 2 sec. or more.
CQ-C8401W/C7401W
11