Table of Contents
Advertisement
4 4
Installation of Fireplace
CAUTION
Sharp Edges
•
Wear protective gloves and safety glasses
during installation.
A. Install the Dual Cooling Air Kit
The cooling air kit is supplied as a standard feature with this
fi replace and is required for safe operation. Installation must
be done at the time of initial construction. The cooling air in-
let tubes must be a minimum of 72 in. (1829 mm) above the
base of the fi replace to prevent potential blockage by snow
or yard debris. See Figure 4.1.
To install the air kit collar, slide one of the tabs down into the
seam. See Figure 4.2. Secure the collar tabs to the fi replace
with screws placed into the holes provided. See Figure 4.3.
Repeat for other side.
Note: The cooling air kit must terminate at least 6 ft. (1.83 m)
above ground level.
72 in.
min.
Figure 4.1
Cooling Air Location
Heat & Glo LifeStyles Collection • Montana-42C • 4039-155 Rev D • 03/06
TR11
Termination
Figure 4.2
Cap
Figure 4.3
WARNING
Fire Risk
Asphyxiation Risk
Do not draw outside combustion air from:
•
Wall, fl oor or ceiling cavity.
•
Enclosed space such as an attic or
garage.
•
Close proximity to exhaust vents or
chimneys.
Fumes or odor may result.
Slide the Tabs
Secure the Tabs
13
Advertisement
Table of Contents
