Kodak NovaJet 850 Training Manual page 27

7. Larger than normal ink droplets (0.5- 2 mm) on the media are caused by
excessive pressure in the cartridge. Ensure the cartridge only has 20 ml
of ink inside and the ink reservoirs do not have more than 400 ml of ink
inside. Printer stand surface or floor area must be level and flat.
8. Microbanding is typically caused by incorrect printer calibrations or low
pass printing. Print pass modes of 4 or lower may cause banding (refer to
Section C.8. above). Ensure all calibrations are performed correctly.
Defective or clogged cartridges may also cause micro-banding. Perform
printer calibrations and replace associated cartridge (s) to verify.
NovaJet 800 Series Training Guide
208 Jet Cartridge
27