Hose Attachment - Husqvarna 968999195 Operator's Manual

Hose Attachment

NOTE: Hoses may need to be trimmed to fit.
If necessary, see the Hose Trimming section
at the end of the Assembly Instructions.
Tools Required: Flat screwdriver
Upper
Hose
Hose
Clamp
Hose
Clamp
ASSEMBLY
1. Slide one Hose Clamp over each end of the
Upper Hose. Slide one end of the hose over
the Vacuum discharge opening and the other
end over the Inlet. Tighten the Hose Clamps
to secure hose in place.
2. Slide one Hose Clamp over each end of the
Lower Hose. Slide one end of the hose over
the Vacuum Inlet Cover. Slide the other end
over the Boot discharge opening. Tighten
the Hose Clamps to secure hose in place.
Lower
Hose
Boot
12
Inlet
Hose
Clamp