Handle Attachment - Husqvarna SC18 Workshop Manual

* Use the following steps to install the handle assembly on your new Husgvarna Sod Cutter
1. Insert one side of the handle into the tube located in front of the large black rubber handle
mount. Make sure to keep the rubber sleeve on the standoff located on the handle.
2. Spread the handle apart so that you can insert the other side of the handle in the same manner
as stated in step number one.
3. Using the four 8 mm x 18 mm (gr. 8) bolts, lockwashers and flat washers (flat washers
against the handle and lockwashers on top), bolt the handle into the large black rubber handle
mount and tighten securely with loctite. DO NOT CROSS THREAD THE BOLTS!
4. Place the depth handle into the "U" brackets on the main handle and secure with the 5/16"
clevis pins and "C: clips.
5. Attach the throttle cable to the clutch handle using the fasteners located on the cable
assembly as illustrated in Figure 1, making sure that the cable pivots freely after you have
tightened the bolts.

HANDLE ATTACHMENT

Important
**
14
SC18 Sod Cutter
Handle Attachment
**