Checking, Maintaining And Servicing The Machine S Safety Equipment - Husqvarna 326HD60 X-series Operator's Manual

Checking, maintaining and servicing
the machine s safety equipment
IMPORTANT! All servicing and repair work on the machine
requires special training. This is especially true of the
machine s safety equipment. If your machine fails any of the
checks described below you must contact your service
agent. When you buy any of our products we guarantee the
availability of professional repairs and service. If the retailer
who sells your machine is not a servicing dealer, ask him for
the address of your nearest service agent.
WARNING! Never use a machine with faulty
!
safety equipment. The machine's safety
equipment must be checked and maintained
as described in this section. If your machine
fails any of these checks contact your
service agent to get it repaired.
WARNING! Always stop the engine before
!
doing any work on the cutting attachment.
This continues to rotate even after the
throttle has been released. Ensure that the
cutting attachment has stopped completely
and disconnect the HT lead from the spark
plug before you start to work on it.
Throttle lock
• Make sure the throttle control is locked at the idle setting
when the throttle lock is released.
• Press the throttle lock and make sure it returns to its
original position when you release it.
• Check that the throttle control and throttle lock move freely
and that the return springs work properly.
6 –
English
SAFETY INSTRUCTIONS
• See instructions under the heading Start. Start the hedge
trimmer and apply full throttle. Release the throttle trigger
and check that the blades stop and remain stationary. If
the blades move when the throttle trigger is in the idle
position then the carburettor idle setting must be adjusted.
See instructions under the heading Maintenance.
Stop switch
• Start the engine and make sure the engine stops when
you move the stop switch to the stop setting.
Hand guard
• Check that the hand guard is fitted correctly.
• Check that the hand guard is undamaged.
Vibration damping system
• Regularly check the vibration damping units for cracks or
deformation.
• Check that the vibration damping element is undamaged
and securely attached.