Hitachi ALPHA SERIES L32A404 Owner's Manual page 7

How To Install Your New Hitachi LCD Television
Take the following precautions to prevent the LCD Television from tipping over and possibly causing injury. It is important to
mount the unit on a stable and flat surface.
ASSEMBLY OF THE BASE
IMPORTANT:
The base of the LCD TV must be assembled prior to use.
1. Place the TV unit face down on a soft and flat surface
covered by a blanket, foam, cloth, etc. to prevent any
damage or scratches to the LCD TV.
2. Carefully align and insert the Base to the TV stand post.
3. Insert the screws included with the accessories to the bottom
of the base and tighten the base to the stand.
Caution when moving the main unit
As this product is heavy, whenever it is moved, at least two people
are required to transport it safely. Whenever the unit is moved, it
should be lifted forward using the top and bottom on both sides of
the Television for stability.
When moving the Television, lift from the corners, then support
the top frame as shown below.
Please use caution when handling the left and right bottom
corners of the TV, as these areas protrude slightly from the TV's
frame. Handle this area with care to avoid damaging the unit and
the possibility of personal injury.
Location
Select an area where sunlight or bright indoor illumination will not
fall directly on the picture screen. If so, drapes or screens can be
used to reduce the reflection.
Also, be sure that the location selected allows a free flow of
air to and from the perforated back cover of the set. In order to
prevent an internal temperature increase, maintain a space of 10
cm (4 inches) from the sides/back of the Television, and 30 cm
(12 inches) from the top of the television to the ceiling. To avoid
cabinet warping, cabinet color changes, and increased chance of
set failure, do not place the TV where temperatures can become
excessively hot, for example, in direct sunlight or near a heating
appliance, etc.
30 cm (12 inches)
10 cm
(4 inches)
NOTES
Power Cord Installation
The power cord provided with your new LCD Television needs to
be installed correctly to avoid its disconnection when rotating the
TV on its Table Top Stand.
Located on the back of the TV there is one plastic clamp to hold the
Power cord. Please follow the instructions below.
1. Pass the power cord through the wire clamp and connect it to the
TV.
2. Close the clamp to fix the power cord to the TV.
3. All the cables connected to the TV will be held by this clamp
Securing to a Wall
1. Use a metallic wire (two locations) to fasten the set to the
clamping screw on the rear of the LCD TV as shown below.
2. Keep the LCD television 4 inches away from the wall, except
when mounted using the wall mount bracket, and secure to
the wall as shown below:
Screw
10 cm
(4 inches)
• Do not block the ventilation holes of the LCD
Television. Blocking the ventilation holes might
cause overheating and damage.
• In case of an abnormal symptom, unplug the
power cord and contact 800.HITACHI.
• If you purchased a wall mount bracket, it is
recommended that you ask for professional
installation.
• Install the unit at a proper area where it does not
expose anyone to any danger of hitting themselves
(For example: their hands, head or face, etc.)
against the edge of the unit that could cause
personal injury.
Wire
Clamp
32"
42"
.
Wire Clamp
A
Wire
Wire
A
4 in.
(10 cm)
7