Hitachi ALPHA SERIES L32A404 Owner's Manual page 12

Quick Setup Guide
Perform the following steps to quickly setup your new
Hitachi LCD Television Set.
1. ANTENNA CONNECTION
Unless your LCD Television is connected to a cable TV system or
to a centralized antenna system, a good outdoor color TV antenna
is recommended for best performance. However, if you are located
in an exceptionally good signal area that is free from interference
and multiple image ghosts, an indoor antenna may be sufficient.
a). VHF (75-Ohm) antenna/CATV (Cable TV)
When using a 75-Ohm coaxial cable system, connect the CATV coaxial
cable to the AIR/CABLE (75-Ohm) terminal. Or if you have an antenna,
connect the coaxial cable to the same AIR/CABLE terminal.
To outdoor Antenna
or
Cable TV (CATV)
System
2. CONNECT YOUR NEW HITACHI LCD TV TO THE POWER SOURCE
a). Connect the power cord to your TV set and secure it with the
wire Clamp (see page 7)
b). Connect the power code to the AC outlet.
3. POWER ON/OFF YOUR NEW HITACHI LCD TV
Press the POWER button on the remote control or the POWER
button on the Side Control Panel to power on/off the LCD TV.
If the Indicating lamp is off, the POWER button
NOTE
on the remote control will not operate. Please
make sure that the power cord is plugged to the
AC outlet.
4. FOLLOW THE SETUP WIZARD INSTRUCTIONS ON NEXT PAGE
12
To AIR/CABLE
Terminal
.
Wire Clamp
AIR/CABLE
c). The Indicating Lamp will light red (Standby modes) and then
light blue (picture is shown).
P.MODE S.MODE MTS/SAP ASPECT
1 2 3
4 5 6
7 8 9
0
ENTER
LAST CH
VOL CH
MUTE
E.SAVE CC SLEEP FAV.CH
MENU INPUT
For Stand-By
SELECT
EXIT INFO
Power OFF
CLU-4591AV
RGB
Rear Panel Jack
Indicating
Lamp
4
or
5
2
3
1