Remote Control Battery Installation And Replacement - Hitachi 42HDT51 Operating Manual

Check to make sure you have the following accessories before disposing of the packing material.
REMOTE
CONTROL
CAUTION: 1. Ceiling mounting is not recommended. Mounting the panel on the ceiling does not provide adequate
ventilation for the electronics or proper support for the front glass panel. This plasma television product is
designed for a maximum tilting angle of 45 degrees from vertical.
2. This TTS55 stand for use only with Hitachi 55HDT51. Use with other apparatus is capable of resulting in
instability causing possible injury. See important marking located on bottom of stand.
1. Remote Control Unit CLU-3841WL (P# HL02061)
or CLU-3843WL (P# HL02063).
2. Two "AA" size, 1.5V batteries (P# FQ00021).
3. Power Cord:
42"
Plasma Monitor EV01841
AVC EV01841
4. Monitor Connection Cable (P# EW07883).
5. Two IR Mouse cables (P# EY01641).

REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT

1. Open the battery cover of the remote control by pushing the notched part of the cover with your fingers and pulling the
cover off.
2. Insert two new "AA" size batteries for the remote control. When replacing
old batteries, push them towards the springs and lift them out.
3. Match the batteries to the (+) and (-) marks in the battery compartment.
4. Replace the cover.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace with the same or equivalent type.
BATTERIES POWER CORD
2.
TTS55 Table Top Stand
(optional)
1.
55"
EV01841
EV01841
MONITOR
CONNECTION CABLE
3.
Cleaning Cloth
Subwoofer Cable
6.
7.
6. 55" Table Top Stand (TTS55) (P# QJ01441K) (Optional).
7. Sub Woofer Cable (P# VZ11701).
8. Cleaning Cloth (P# MS00931).
9. Speaker wires (for monitor speakers).
4
ACCESSORIES
IR MOUSE
CABLE
4. 5.
Speaker Wires
9.
8.
BOTTOM VIEW
(Remote Control)
Press down and slide back
to remove.