Remote Control Battery Installation And Replacement - Hitachi 42HDF52A Operating Manual

ACCESSORIES
Check to make sure you have the following accessories before disposing of the packing material.
REMOTE
CONTROL
CAUTION: Ceiling mounting is not recommended. Mounting the panel on the ceiling does not provide adequate
1. Remote Control Unit
2. Power Cord
3. D-SUB Mini 15-Pin Cable
4. Audio/Video Cable
5. S-Video Cables

REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT

1. Open the battery cover of the remote control by pressing the notched part of the cover
with your fingers and pulling the cover off.
2. Insert two new "AAA" size batteries for the remote control. When replacing old batteries,
push them towards the springs and lift them out.
3. Match the batteries to the (+) and (-) marks in the battery compartment.
4. Replace the cover.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace with the same or equivalent type.
POWER CORD D-SUB MINI 15-PIN
CABLE
2.
BATTERIES USER'S GUIDE
1.
6.
ventilation for the electronics or proper support for the front glass panel. This plasma television
product is designed for a maximum tilting angle of 45 degrees from vertical.
AUDIO/VIDEO
CABLE
3.
EASY GRAPHIC
GUIDE
7.
6. Two "AAA" size, 1.5V batteries
7. User's Guide
8. Easy Graphic Guide
9. Warranty Card
7
S-VIDEO CABLE
4. 5.
WARRANTY CARD
8. 9.