Remote Control Battery Installation And Replacement - Hitachi 32HDT50 Operating Manual

Check to make sure you have the following accessories before disposing of the packing material.
REMOTE
CONTROL
POWER
VCR CBL
TV
STB
SOURCE WIZARD
CD PVR
DVD AMP
1 2 3
4
5 6
7 8 9
0
SLEEP INFO
A/V NET
SELECT
VOL CH
VID 3
PIP SURF FREEZE
PIP ACCESS
SWAP
PIP MODE DAY/NIGHT
REC
PDP TV STAND (OPTIONAL)
32" (SPD32 P#H520441)
42" (SPD42 P#H520442)
9.
CAUTION: 1. The plasma display wall mount unit WM50 is for use only with Hitachi model 32HDT50, 42HDT50 and
50HDT50.
2. Ceiling mounting is not recommended. Mounting the panel on the ceiling does not provide adequate
ventilation for the electronics or proper support for the front glass panel. This plasma television product is
designed for a maximum tilting angle of 45 degrees from vertical.
3. This SPD32 PDP stand for use only with Hitachi 32HDT50. Use with other apparatus is capable of resulting
in instability causing possible injury.
4. This SPD42 PDP stand for use only with Hitachi 42HDT50. Use with other apparatus is capable of resulting
in instability causing possible injury.
5. This 50STD3 stand for use only with Hitachi 50HDT50. Use with other apparatus is capable of resulting in
instability causing possible injury. See important marking located on bottom of stand.
1. Remote Control Unit CLU-5726TSI (P# HL01826).
2. Two "AA" size, 1.5V batteries (P# FQ00021).
3. Power Cord:
32"/42"
Plasma Monitor EV01841
AVC EV01841
4. Monitor Connection Cable (P#EW07883).
5. Two IR Mouse cables (P# EY01641).
6. Speaker Accessories (42" only) (P#GM01193).

REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT

1. Open the battery cover of the remote control by pushing the notched part of the cover with your fingers and pulling the
cover off.
2. Insert two new "AA" size batteries for the remote control. When replacing
old batteries, push them towards the springs and lift them out.
3. Match the batteries to the (+) and (-) marks in the battery compartment.
4. Replace the cover.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace with the same or equivalent type.
BATTERIES POWER CORD
2.
SPEAKER ACCESSORIES
(42")
1.
50STD3 Table Top Stand
10.
50"
EV01861
EV01841
MONITOR
CONNECTION CABLE
3.
SPEAKER ACCESSORIES
(50")
6.
Subwoofer Cable Cleaning Cloth
11. 12.
7. Speaker Accessories (50" only) (P#GM01232).
8. Wall Mount Unit WM50 (Optional) (P#QX00563).
9. 32" Stand (SPD32 P# H520441) (Optional).
42" Stand (SPD42 P# H520442) (Optional).
10. 50" Table Top Stand (50STD3) (P#QD35632).
11. Sub Woofer Cable (P# VZ11701).
12. Cleaning Cloth (P#MS00803).
13. AVC Stand Accessories (P#QJ01081).
4
ACCESSORIES
IR MOUSE
CABLE
4.
WALL MOUNT UNIT WM50
(OPTIONAL)
7.
AVC Stand
Accessories
13.
BOTTOM VIEW
Lift up on tab to
remove back cover.
5.
8.