Table of Contents
Advertisement
The exact arrangement you use to connect the VCR, camcorder, laserdisc player, DVD player, or HDTV Set Top Box to your LCD TV
is dependent on the model and features of each component. Check the owner's manual of each component for the location of video
and audio inputs and outputs.
The following connection diagrams are offered as suggestions. However, you may need to modify them to accommodate your
particular assortment of components and features. For best performance, video and audio cables should be made from coaxial
shielded wire.
Before Operating External Video Source
Connect an external source to one of the INPUT terminals, then press the INPUTS button to show the INPUTS menu. Use the
CURSOR PAD (
and
) to select the Antenna or Input of your choice. Then press the SELECT button or the CURSOR PAD
confirm your choice (see page 33).
CONNECTING A MONAURAL AUDIO SOURCE TO INPUT1~INPUT5
1.
Connect the cable from the VIDEO OUT of the VCR or the laserdisc player to the INPUT (VIDEO) jack, as shown on the AVC
Center below.
2.
Connect the cable from the AUDIO OUT of the VCR or the laserdisc player to the INPUT (MONO)/L(AUDIO) jack.
3.
Press the INPUTS button, then select INPUT 3 from the INPUTS menu to view the program from the VCR or the laserdisc player.
The VIDEO label disappears automatically after approximately four seconds.
4.
Select Ant A or B from the INPUTS menu to return to the previous channel.
CONNECTING EXTERNAL VIDEO SOURCES
Photo Input
Ant B
Ant A
Input 1
Input 2
Move
Sel.
SEL
VIDEO OUT
AUDIO OUT
VCR
16
Back of VCR
to
or
Advertisement
Table of Contents
