Input Level - Hitachi 32HDT50 Operating Manual

RGB ASPECT DISPLAY MODE.
NOTES: 1. Lack of raster can be seen in RGB when a 480p signal is input.
2. AUTO ADJUST function (see page 72) is not available in 720p, 1080i, and 480p input signal.
3. FULL aspect mode, only 95% of information can be displayed (5% is treated as overscan).
4. 50" only.
Select the Input Level voltage between 0.7V and 1.0V.

INPUT LEVEL

Video
Auto Adjust
Horizontal Position
Vertical Position
Horizontal Clock
Clock Phase
Reset
Input Level
Black Side Panel
Move Select
SEL
BLACK SIDE The BLACK SIDE PANEL function turns the gray side bars ON/OFF when watching Aspect
PANEL
in Real and Normal signals in Standard Mode.
Video
Auto Adjust
Horizontal Position
Vertical Position
Horizontal Clock
Clock Phase
Reset
Input Level
Black Side Panel
Select
Move
SEL
NOTE: To prevent the plasma phosphor from burning when watching Aspect in Real and Normal signal, turn off the BLACK SIDE
PANEL. It is recommended to watch 4:3 signal with gray side bar.
RGB (Analog) INPUT SIGNAL
Others SVGA/XGA(4)
X REAL
ASPECT
NORMAL NORMAL
MODE
FULL FULL
AVAILABILITY
For numbers in ( ), please see corresponding note below.
Use THUMB STICK
Adjust
1.0V depending on the amount of brightness in the
0
picture.
0
0
0
Reset
0.7V
Off
Press down on THUMB STICK to select BLACK SIDE
PANEL ON/OFF.
Adjust
0
0
0
0
Reset
0.7V
Off
RGB ON SCREEN DISPLAY
VGA 480p 720p
REAL REAL(1) X
NORMAL NORMAL(1) X
FULL FULL(1) FULL(2,3) FULL(2,3)
, to select between 0.7V and
74
1080i
X
X