Brother DCP-19010CN User Manual page 64

Error Message
Cooling Down
Wait for a while
Cover is Open
Cover is Open
DIMM Error
Document Jam
Drum Error
1
Drum End Soon(X)
Drums End Soon
Fuser Error
56
Cause
The temperature of the drum unit
or toner cartridge is too hot. The
machine will pause its current
print job and go into cooling down
mode. During the cooling down
mode, you will hear the cooling
fan running while the LCD shows
Cooling Down, and
Wait for a while.
The ADF cover is not closed
completely.
The top cover is not closed
completely.
The fuser cover is not closed
completely or paper was jammed
in the back of the machine when
you turned on the power.
The DIMM is not installed
correctly. Or the DIMM is broken.
The document was not inserted
or fed correctly, or the document
scanned from the ADF was too
long.
The corona wire on the drum unit
needs to be cleaned.
It is time to replace the drum
units.
The drum unit for the colour
indicated on the LCD is near the
end of its life.
The drum units are near the end
of their life.
The temperature of fuser unit
does not rise at a specified
temperature within specified time.
The fuser unit is too hot.
Action
Make sure that you can hear the fan in the
machine spinning and that the exhaust outlet
is not blocked by something.
If the fan is spinning, remove any obstacles
that surround the exhaust outlet, and then
leave the machine turned on but do not use
it for several minutes.
If the fan is not spinning, disconnect the
machine from the power for several minutes,
then reconnect it.
Close the ADF cover of the machine, then
press Stop/Exit.
Close the top cover of the machine.
Close the fuser cover of the machine.
Make sure paper is not jammed inside
the back of the machine, and then close
the fuser cover and press Mono Start or
Colour Start.
Turn off the machine. Re-install the DIMM
correctly. Wait a few seconds, and then turn
it on again. If this error message appears
again, replace the DIMM with a new one.
(See Installing extra memory on page 41.)
See Document jams on page 60 or Using the
automatic document feeder (ADF)
on page 21.
Clean the corona wire on the drum unit. (See
Cleaning the corona wires on page 69.)
Replace the drum unit with a new one for the
colour that is indicated on the LCD. (See
Replacing the drum units on page 86.)
Buy new drum unit for the colour indicated on
the LCD before you get a
1
message.
Replace Drum(X)
Buy new drum units before you get a
Replace Drums message.
Turn the power switch off, wait a few
seconds, and then turn it on again. Leave the
machine for 15 minutes with the power on.