Brother DCP-195C Quick Setup Manual

Unpack the machine and check the components
1
Start Here
IMPORTANT
DO NOT connect
the USB cable yet.
a.
Warnings tell you what
b.
WARNING
to do to prevent possible
personal injury.
c.
Illustrations in this Quick Setup Guide are
based on the DCP-195C.
c.
Press and slide the
paper side guides
a
and paper length
guide b to fit the
paper size.
Make sure that the
triangular marks c
on the paper side
guides a and paper
length guide b line
up with the mark for
the paper size you
are using.
3
Set the language (not available for HongKong/Taiwan users)
4
a. c.
When the LCD shows this Press a (Yes) to confirm the
message, press OK. language setting.
Select Language
Press OK Key
Note
b.
Press a or b to choose your If you set the wrong language,
you can change it again after
language and press OK.
setting the date and time.
e
English (For details see Changing LCD
language in Chapter 3 of the
User's Guide.)
Select ab & OK
Check the print quality
6
a. b.
When the preparation process Check the quality of the four colour
has finished, the LCD shows this blocks a on the sheet.
message. (black/yellow/cyan/magenta)
Set Paper and
Press Start
Press Colour Start.
o If all lines are clear and visible, press
to finish the quality check.
o If you can see missing short lines, press
and follow the steps on the LCD.
Before you can use the machine, read this Quick Setup Guide
for the correct setup and installation.
LX1506040
ARL/ASA/NZ/SAF
Printed in China
Note
• The components of your box may differ depending on your country.
• Save all packing materials and the box in case for any reason
you must ship your machine.
• Your machine has a USB interface that is compatible with the
USB 2.0 specifi cation.
• To ensure safe operation the supplied plug must be inserted
only into a standard power outlet that is properly grounded
through the standard electrical wiring. Non grounded
equipment may cause an electrical shock hazard, and may
cause excessive electrical noise radiation.
Remove the protective tape and film.
Remove the plastic bag a containing the ink cartridges from
on top of the paper tray.
1 Approx. 65% yield of the replacement cartridge. For details, see
Consumable items in the User's Guide.
Make sure you have all components.
1
3
2
IMPORTANT
DO NOT push the
paper in too far.
Install the ink cartridges
5
a. c.
The LCD shows:
No Cartridge
b.
Open the ink cartridge cover a.
1
Set the LCD contrast (if needed)
7
a.
b.
c.
1
d.
OK
a (Yes)
e.
Poor
b (No)
Inbox Ink
1
1 Cartridges [x4]
Black
Yellow
Cyan Hong Kong,
Australia &
Malaysia &
Magenta
New Zealand
Singapore
The supplied mains plug is a grounded three
Power Cord CD-ROM
pin plug.
USB
Interface
WARNING
Cable
Plastic bags are used in the packaging of your machine. To avoid
Quick Setup
User's Guide
Guide danger of suffocation, please keep these bags away from babies
and children.
d. g.
Fan the stack of paper well. Close the output paper tray
cover and slowly push the
e.
Gently put the paper into paper tray back into the
the paper tray. Check that machine.
the paper is flat in the tray.
f.
Gently adjust the paper side
guides to the paper with
both hands.
Make sure the paper side
guides touch the edges of
the paper.
d.
Remove the green protective part a. Unpack the ink cartridge.
Turn the green knob on the protective yellow cap
clockwise until it clicks to release the vacuum seal,
then remove the cap a.
1
1
Set the date and time
8
a.
Press Menu.
Press a or b to choose
b.
0.Initial Setup, and then press OK.
Press a or b to choose
2.LCD Contrast, and then press OK.
c.
Press a or b to choose Dark or Light.
Press OK and then Stop/Exit.
Load plain A4 paper
2
a.
Pull out the paper tray.
Philippines &
SouthAfrica
Thailand
The supplied mains
plug is a side grounded
two pin plug.
Connect the power cord
3
h.
Pull out the paper support a until
it clicks, and then unfold the paper
support flap b.
2
1
e.
Install each ink cartridge in the direction
of the arrow on the label.
Take care to match the colour of the
lever a with the cartridge colour b.
1
2
d.
Press Menu. Press a or b repeatedly to enter the last two digits of
the year, and then press OK.
Year:2009
Press a or b to choose
0.Initial Setup, and then press OK.
(e.g. Enter 09 for 2009.)
e.
Repeat for Month and Day, and Hours and Minutes
Press a or b to choose
in 24-hour format.
1.Date&Time, and then press OK.
f.
Press Stop/Exit.
Note
If you make a mistake and want to start again,
press Stop/Exit to go back to step a.

Quick Setup Guide

DCP-195C
b.
Lift the output paper tray cover a.
1
a.
Connect the power cord.
WARNING
The machine must be fi tted with an earthed plug.
IMPORTANT
DO NOT connect the USB cable
yet.
Note
The Warning LED on the control
panel will stay on until you have
installed the ink cartridges.
f.
Gently push the ink cartridge until it clicks. After all the ink
cartridges are installed close the ink cartridge cover.
IMPORTANT
After initial installation of the ink cartridges, the machine will start cleaning the
ink tube system. This cleaning process will last approximately four minutes.
DO NOT unplug the machine from the power outlet or attempt to stop the
cleaning process. Interruption of cleaning process may cause undesired print
quality problems.
Turn the sheet over.