Dell Latitude C610 User Manual page 104

8.
NOTICE: Handle memory modules by their edges, and do not touch the components on a module.
a. Use your fingertips to carefully spread apart the securing clips on each end of the memory
module connector.
The module should pop up.
b. Remove the module from the connector.
NOTICE: If you need to install memory modules in two connectors, install a memory module in the
connector labeled "JDIM1 (DIMMA)" before you install a module in the connector labeled "JDIM2
(DIMMB)."
9. Ground yourself and install the new memory module:
a. Align the notch in the module with the slot in the center of the connector.
b. Slide the edge of the module firmly into the connector, and rotate the module down until you feel
a click. If you do not feel the click, remove the module and reinstall it.
NOTE: If the memory module is not installed properly, the computer does not boot. No error message
indicates this failure.
10. Replace the cover and screw(s).
NOTICE: If the memory module cover is difficult to close, remove the module and reinstall it. Forcing
the cover to close may damage your computer.
11.