7.
Shut down the
computer.
NOTICE:
To disconnect a network cable, first unplug the cable from your computer, and then unplug it from the network wall jack.
8. Turn off any attached devices and disconnect them from their electrical outlets.
9. Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board.
10.
Open the computer
cover.
11. Reconnect the jumper plug to
12.
Close the computer
cover.
NOTICE:
To connect a network cable, first plug the cable into the network wall jack, and then plug it into the computer.
13. Connect your computer and devices to electrical outlets, and turn them on.
Turning on your computer with the PSWD jumper installed reenables the password feature.
Back to Contents Page
jumper
PSWD.