Selecting The Start-Up Configuration File; Copying The Running Configuration To A File - Dell PowerConnect 5224 System User's Manual

2. In the Source File Name field, select the configuration file to upload from the drop-down menu.
3. For the Destination File Name, type a filename to identify the configuration file on the TFTP server.
4. Click Transfer to Server.
Transferring a Configuration File from a Server
1. Under Transfer Configuration File from Server, enter the IP address of the TFTP server in the TFTP Server IP Address field.
2. In the Source File Name field, type the filename of the configuration file to download.
3. In the Destination File Name field, select a configuration file to replace from the drop-down menu, or specify a new filename (with no more than 32
characters). Filenames are case sensitive and cannot contain spaces. The switch can contain any number of configuration files, limited only by available
flash memory space. You can use the dir command in the CLI to check the available flash memory space.
4. Click Transfer from Server.
NOTE: The CLI also allows you to copy files within the switch and replace a running configuration file without performing a reset.
Deleting a Configuration File from the Switch
1. In the Remove Configuration File field, select the file to delete from the drop-down menu.
2. Click Remove File.

Selecting the Start-up Configuration File

1. In the Start-Up Configuration File field, select the start-up configuration file from the drop-down menu.
2. Click Apply Changes.

Copying the Running Configuration to a File

1. In the Copy Running Config to File field, specify a filename for the configuration file (with no more than 32 characters). If the filename already exists, it
replaces the file. The filename cannot be the same as the factory default configuration file, Factory_Default_Config.cfg.
2. Click Copy to File.
CLI Commands
The following table summarizes the equivalent CLI commands for items in the Switch/Configuration web page.
Command
copy file {file | running-config | startup-
config | tftp}
Usage
Uploads/downloads a configuration file to/from the switch's flash
memory to a TFTP server