Cli Commands - Dell PowerConnect 5224 System User's Manual

CLI Commands

The following table summarizes the equivalent CLI commands for items in the Switch/IP Address page.
Command Usage
ip address {ip-address Sets the primary IP address for this device. Use the no form command to
netmask | bootp | dhcp} remove the IP address, or to disable IP address assignment through BOOTP or
DHCP.
ip default-gateway Establishes a static route between the switch and management stations that
gateway exist on another network segment.
show ip interface Displays the usability status of an IP interface.
show ip redirects Shows the default gateway configured for this device.
Example
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.5 255.255.255.0
Console(config-if)#exit
Console(config)#ip default-gateway 192.168.1.254
Console(config)#
DHCP
In the DHCP page, click Restart DHCP to release the current IP address and obtain a new one through DHCP.
NOTICE: If Restart DHCP is selected when IP settings have been configured statically, a warning message indicating that the IP Address Mode is not
set to DHCP displays.
CLI Commands
The following table summarizes the equivalent CLI command for items in the Switch/IP Address/DHCP page.
Command
ip dhcp restart
Security
The Security page contains links to the following information:
Usage
Resubmits a DCHP client request