WeiderPro 831.14923.1 User Manual page 20

29. See the CABLE DIAGRAM. Identify the High
Cable (44).
Route the High Cable (44) upward through the
Top Frame (6) and over a Pulley (69). Make
sure that the eyelet end of the High Cable is
in the location shown.
Attach the Pulley (69) inside the Top Frame (6)
with an M10 x 68mm Bolt (66), two 14.8mm
Spacers (95), and an M10 Locknut (74).
30. Route the High Cable (44) over a Pulley (69).
Attach the Pulley (69) and a Cable Trap (71) to
the indicated side of the Top Frame (6) with an
M10 x 93mm Bolt (63), an M10 Washer (88), and
an M10 Locknut (74). Make sure that the Cable
Trap is oriented to hold the High Cable in the
groove of the Pulley.
31. Route the High Cable (44) under a V-pulley (67).
Attach the V-pulley (67) and a Cable Trap (71)
to the Upright (5) with an M10 x 57mm Bolt (93)
and an M10 Locknut (74). Make sure that the
Cable Trap is oriented to hold the High Cable
in the groove of the V-pulley.
29
69
74
95
44
Eyelet
End
30
71
74
44
31
67
44
20
6
95
66
69
6
88
63
93
71
5
74