Using The Genius Remote To Control Cable Box Functions - Hitachi 31CX4B, 31UX5B Operating Manual

USING THE GENIUS REMOTE TO CONTROL
CABLE BOX FUNCTIONS
USING THE GENIUS REMOTE TO CONTROL
CABLE BOX FUNCTIONS
Operating the pre-coded function for your Cable Box
This Genius Remote is designed to operate different types of cable boxes. You must first
program the Genius Remote to match the remote system in your cable box. (Refer to Table 2 on
page 31 or Table 4 on page 32.)
1. Set the MULTI-PAGE select switch to "CATV".
2. Set the USE/LEARN mode select switch to "USE." (For CLU-851GR only)
3. Turn ON your cable box.
4. Aim the Genius Remote control at the front of your cable box.
5. While holding down the SELECT button, press the button that matches our cable box as
shown on page 31 or page 32. Continue to hold down both buttons. The channels of the cable
box will begin changing when the correct button is pressed. When this occurs, the Genius
Remote Control is programmed for your cable box. If the cable box channels do not change after
5 seconds, try a different Genius Remote button.
6. Release both buttons when the cable box starts to change channels. The Genius Remote will
now control your cable box.
Click here to see the CLU-851GR in the CATV position.
NOTES:
1. If your cable box cannot be operated after performing the above procedures, this means that your
cable box codes have not been precoded into the GENIUS REMOTE. Please store your cable box
codes in memory by using the USER mode. (Refer to page 33.)
2. The GENIUS REMOTE CONTROL will remember the codes you have programmed in until the
batteries are removed from the GENIUS REMOTE CONTROL. After replacing the batteries repeat
the entire programming procedure stated above.
Q Q Q Q PRECODED FOR CABLE BOX
These buttons always transmit the chosen precoded CATV codes.
R R R R SELECT BUTTON
38